Applied-motion SWM24IP-3EE Manual do Utilizador descarregar pdf (Página 12)

If you plan to use a regulated power supply you may encounter a problem with regeneration. If you rapidly decelerate a

load from a high speed, much of the kinetic energy of that load is transferred back to the power supply. is can trip the

over-voltage protection of a switching power supply, causing it to shut down. We oer the RC-050 “regeneration clamp”

to solve this problem. If in doubt, buy an RC-050 for your rst installation. If the “regen” LED on the RC-050 never ashes,

you don’t need the clamp.

RC-050 Regen Clamp

+5V Keep-Alive Feature:

+5Volts can be fed to the +5V terminal to keep the logic alive when the DC bus voltage is removed. is is very useful

when an encoder is present, as the position of the system is then known when the DC bus is re-applied. An internal volt-

age fault will have to be cleared and the motor re-enabled when the DC bus is re-applied. A .4 Amp or larger supply is

required for the keep-alive supply.

SWM24 Hardware Manual

920-0068B

10/31/2013

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sem comentários

Applied-motion SWM24IP-3EE Manual do Utilizador Página 12