Applied-motion STM17C-3CE Manual do Utilizador descarregar pdf (Página 6)

Safety Instructions

Only qualied personnel are permied to transport, assemble, commission, and maintain this equipment. Properly quali-

ed personnel are persons who are familiar with the transport, assembly, installation, commissioning and operation of

motors, and who have the appropriate qualications for their jobs. e qualied personnel must know and observe the

following standards and regulations:

IEC 364 resp. CENELEC HD 384 or DIN VDE 0100

IEC report 664 or DIN VDE 0110

National regulations for safety and accident prevention or VBG 4

To minimize the risk of potential safety problems, you should follow all applicable local and national codes that regulate

the installation and operation of your equipment. ese codes vary from area to area and it is your responsibility to de-

termine which codes should be followed, and to verify that the equipment, installation, and operation are in compliance

with the latest revision of these codes.

Equipment damage or serious injury to personnel can result from the failure to follow all applicable codes and standards.

We do not guarantee the products described in this publication are suitable for your particular application, nor do we

assume any responsibility for your product design, installation, or operation.

•Readallavailabledocumentationbeforeassemblyandcommissioning.Incorrecthandlingofproductsinthismanual

can result in injury and damage to persons and machinery. Strictly adhere to the technical information on the installation

requirements.

•Itisvitaltoensurethatallsystemcomponentsareconnectedtoearthground.Electricalsafetyisimpossiblewithouta

low-resistance earth connection.

•eSTM17drivescontainelectrostaticallysensitivecomponentsthatcanbedamagedbyincorrecthandling.Dis-

charge yourself before touching the product. Avoid contact with high insulating materials (articial fabrics, plastic lm,

etc.). Place the product on a conductive surface.

•Duringoperationkeepallcoversandcabinetdoorsshut.Otherwise,therearedeadlyhazardsthatcouldpossibly

cause severe damage to health or the product.

•Inoperation,dependingonthedegreeofenclosureprotection,theproductcanhavebarecomponentsthatarelive

or have hot surfaces. Control and power cables can carry a high voltage even when the motor is not rotating.

•Neverpulloutorplugintheproductwhilethesystemislive.ereisadangerofelectricarcinganddangertoper-

sons and contacts.

•Aerpoweringdowntheproduct,waitatleasttenminutesbeforetouchinglivesectionsoftheequipmentorundoing

connections (e.g., contacts, screwed connections). Capacitors can store dangerous voltages for long periods of time aer

power has been switched o. To be safe, measure the contact points with a meter before touching.

Be alert to the potential for personal injury. Follow the recommended precautions and safe operating practices included

with the alert symbols. Safety notices in this manual provide important information. Read and be familiar with these

instructions before aempting installation, operation, or maintenance. e purpose of this section is to alert users to

possible safety hazards associated with this equipment and the precautions that need to be taken to reduce the risk of

personal injury and damage to the equipment.

Failure to observe these precautions could result in serious bodily injury, damage to the equipment, or operational dif-

culty.

STM17 Hardware Manual

920-0034 rev A

9/30/2010

1 2 3 4 5 6 7 8 9 10 11 ... 30 31

Sem comentários

Applied-motion STM17C-3CE Manual do Utilizador Página 6