Applied-motion STR2 Manual do Utilizador descarregar pdf (Página 8)

STR2 Hardware Manual

920-0059B

1/30/2014

Mounting the Drive

You can mount your drive on the wide or the narrow side of the chassis using #6 screws. If

possible, the drive should be securely fastened to a smooth, at metal surface that will help

conduct heat away from the chassis. If this is not possible, then forced airow from a fan may be

required to prevent the drive from overheating. See “Drive Heating” for more details.

• Never use your drive in a space where there is no air ow or where other devices

cause the surrounding air to be more than 50°C.

• Never put the drive where it can get wet or where metal or other electrically con-

ductive particles can get on the circuitry.

• Always provide air ow around the drive. When mounting multiple drives near

each other, maintain at least one half inch of space between drives.

Connecting the Power Supply

If you need information about choosing a power supply, please read the section

Choosing a

Power Supply

• Connect the power supply “+” terminal to the connector terminal labeled “V+”.

• Connect power supply “-” to the connector terminal labeled “V-”.

• e green ground screw on the corner of the chassis should be connected to earth ground.

• Use 18 or 20 gauge wire.

e STR drives contain an internal fuse that connects to the power supply + terminal. is fuse

is not user replaceable. If you want to install a user serviceable fuse in your system install a fast

acting 3 amp fuse in line with the + power supply lead.

Be careful not to reverse the wires. Reverse connection will destroy your

drive, void your warranty and generally wreck your day.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Sem comentários

Applied-motion STR2 Manual do Utilizador Página 8