Applied-motion SVAC3-IP-E120 Manual do Utilizador descarregar pdf (Página 2)

a) Apply power to the drive.

b) Enter the proper IP address (refer to step 1d above), then select the “Drive”

tab and press the “Ping” button. You should receive a response similar to

that shown here.

c) Select the appropriate operating mode for your drive.

d) If using an Applied Motion servomotor, press the “Open” button, navigate to

the SVAC3 folder, and select a tuning le. Select the le that most closely

matches your inertia load. The le names indicate the inertia ratio for

which they were optimized. For example, the le M0200-101-4-X5.svt was

optimized for the M0200-101-4 motor at a 5:1 inertia ratio.

Step 5

a) Select the “Motor - Encoder” tab and conrm settings for motor

maximum current and pole count, as well as the encoder resolution

are correct. If you are using a non-AMP motor, these data must be

obtained from your motor’s datasheet.

b) Execute the Timing Wizard, following the on-screen prompts. This will

ensure that the drive can properly commutate the motor.

Step 6

a) Select the “Tuning - Sampling” tab.

b) If a factory tuning le was used in Step 5, the system is already tuned for the specied load. If using

a third-party motor, the system must be tuned manually. Consult the Quick Tuner™ Software Manual

for step-by-step tuning instructions.

The Quick Tuner™ Software Manual should be considered required reading for anyone tuning a servo

system.

Step 7

Select the “Inputs - Outputs” tab, and congure any dedicated-function I/O your application

may require.

Step 8

Download your settings to the drive. Your drive is now congured for use.

Step 9

If you have any questions or comments, please call

Applied Motion Products Customer Support:

(800) 525-1609, or visit us online:

www.applied-motion.com.

404 Westridge Dr.

Watsonville, CA 95076

Tel: 800-525-1609

Fax: 831-761 -6544

www.applied-motion.com

920-0052 rev A

1 2

Sem comentários

Applied-motion SVAC3-IP-E120 Manual do Utilizador Página 2