Applied-motion BLuAC5-Q Manual do Utilizador descarregar pdf (Página 10)

BLuAC5 S/Q Hardware manual

920-0049 Rev. C

12/8/2014

(5) GND

(4) Drive TX

(3) +5 Volt output for MMI & HUB

(2) Drive RX

DB9 to RJ11 Adaptor Pin assignments

DB9 female Signal Name RJ11 Signal Name

2RX4TX

3TX2RX

5 GND 5 GND

Servo Drive RJ11

(2) PC TX

(3) No Connection

(4) PC Rx

(5) PC Ground

Adaptor RJ11

Adaptor DB9

Front View

PC DB9 to

Servo Drive RJ11 Adaptor

NOTE: Pins 1 & 6 are not connected

Connecting to the PC using RS-232

• Locate your computer within 6 feet of the BLU servo drive.

• Your drive was shipped with a communication cable. Plug the large end into the serial port

of your PC and the small end into the RS-232 jack on your drive. Secure the adapter to the

PC with the screws on the sides.

Never connect a BLU servo drive to a telephone circuit. It uses the same connectors and cords as

telephones and modems, but the voltages are not compatible.

If your PC does not have a serial port, you should purchase a “USB Serial Converter”. We

have had good results with the Port Authority “USB Serial DB9” Adapter from CablesToGo.

com and with the SW1301 from SewellDirect.com.

For laptops, a PCMCIA converter card is a good choice. Our applications engineers use the

SSP-100 from Sewell Direct.

Regeneration LED

This LED indicates when the drive is actively applying the regeneration clamp. The clamp is

the internal circuitry that shunts the DC bus to a power resistor. The power resistor can be

either internal or external. (See “Servo Drive Regeneration” in this manual for more details)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 45 46

Sem comentários

Applied-motion BLuAC5-Q Manual do Utilizador Página 10