Applied-motion BD10-H4-AH Manual do Utilizador descarregar pdf (Página 15)

BD5/10 Drive Hardware Manual

920-0065D

2/14/2014

Motor Test

• Ensure that DIP switch 1 is ON and 2 is OFF (to use internal power supply

for I/O). Note, it may be necessary to remove the external cover to access the internal DIP switches. It may also

be possible to access these switches by carefully reaching through the slots with the small screw driver that is

included.

• Speed and accel/decel seings are controlled by on-board potentiometers, adjustable using the included

screwdriver.

• Plug in both connectors of matching BL motor.

• Apply power to the drive.

• TESTING: To start the motor spinning, connect STP (pin11, black/white)

to GND (pin2) and adjust the SPD pot to the desired speed. To reverse

direction, connect CW/CCW (yellow) to GND (pin2).

Input/Output Connector Wire Colors

e signal names and colors used on the I/O cable provided with each drive are as shown below:

BD5/10

BD5/10 FUNC-

TION

COLOR COLOR CODE

1 5V RED

2 GND BLK

3 CW/CCW YEL

4 FLT+ GRN

5 STMD BLU

6 F LT- ORG

7 EN/RE GRY

8 SPO+ VIO

9 SPST BRN

10 SPO- WHT

11 STP BLK/WHT

12 5V RED

13 M0 YEL/WHT

14 AIN GRN/WHT

15 M1 BLU/WHT

16 AGND BLK

17 M2 RED/WHT

18 INCOM ORG/WHT

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Sem comentários

Applied-motion BD10-H4-AH Manual do Utilizador Página 15