
SSM
SSM23 Q/IP Ethernet
Quick Setup Guide
Requirements
To begin, make sure you have the following equipment:
• Asmallatbladescrewdriverfortighteningtheconnectors(included).
• A12-70VDCpowersupply.
• ApersonalcomputerrunningMicrosoftWindowsXP,Vista,7or8(32or64bit).
• Step-ServoQuickTunersoftware(availableatwww.applied-motion.com/products/software).
• ACAT5networkcable(notincluded).
• Formoredetailedinformation,pleasedownloadandreadtheappropriatehardwaremanual,availableatwww.
appliedmotion.com/support/manuals.
Step1
Step2
a)DownloadandinstalltheStep-ServoQuickTunersoftware.
b)IfyouintendtoconnectthedrivedirectlytoyourPC,congureyourcomputertouseIPaddress10.10.10.11.(For
instructionsonconnectingyourSSMdrivetoalocalareanetwork(LAN),pleaseconsulttheappropriatehardware
manual)
c)OntheSSMdrive,selectswitchposition0,whichwillassignIPaddress10.10.10.10.(Seethehardwaremanual
forfurtherdetailsonselectingIPaddressesforthedriveandPC)
d)Launchthesoftwarebyclicking:Start/AllPrograms/AppliedMotionProducts/Step-ServoQuickTuner
Wire the drive to the DC power source.
(DonotapplypoweruntilStep3)
Note-theSSMdriveacceptsDCvoltagesfrom12-70V.Ifusing
anexternalfuse,werecommenda4ampfastactingfuse.
(See the appropriate hardware manual for more information about
power supply and fuse selection.)
Connect I/O, if required by your application.
(See the appropriate hardware manual for more information about
wiring I/O to the SSM drive.)
GND
+VDC
920-0091A
Comentários a estes Manuais